How do you make an origami endless cube?

Step 1: Fold one piece of paper in half to get the halfway fold mark.

Step 2: Open up the square and fold each side edge to the crease line you created in step 1.
Step 3: Fold the smallest edges over to create a halfway crease going the other way.
Step 4: Repeat five more times using different colors.

How do you make an origami cube sheet?

Chapters

Paper Cubes.
Start with a square piece of paper.
Fold in half diagonally again from the other corners.
Fold all of the corners into the center.
This is to fold the paper into thirds.
Fold the edge of the paper to the mark like shown.
Fold the paper into thirds again from the other side.

How do you make an origami sonobe?

Sonobe Unit Origami

Step 1: Crease Center and Fold Edges to Center.
Step 2: Fold in Half.
Step 3: Fold Diagonals on Top and Bottom.
Step 4: Start to Form First Interlocking Point.
Step 5: Start to Form Second Interlocking Point.
Step 6: Finish Forming Interlocking Point.
Step 7: Fold Into a “W”
Step 8: Finished Unit.

How do you make a origami ninja star?

Cool Uncle Tricks: How to Make a Ninja Star Out of Paper

Step 1: Fold Sheets in Half (Twice)
Step 2: Fold in Half the Long Way.
Step 3: Fold Up, Fold Down.
Step 4: Fold Down, Fold Up.
Step 6: Fold Corners.
Step 7: Fold Corners in Again.
Step 8: Overlap Pieces.
Step 9: Flip and Finish.

How do you make 3D shaped paper?

You need four squares going down and three going across. How to Make a 3d Triangular Prism: The Triangular Prism is made by dividing the paper into thirds. Then in the center section you will make your triangular cut-outs. I measured the sides of my paper sections to make the triangle side the same length.

How do you draw a 3D cube?

How to Draw a Cube – Step by Step

Step 1 – Start by Drawing the Corner Nearest to You. There are a couple of ways to begin drawing your cube.
Step 2 – Draw the Bottom Edges.
Step 3 – Draw the Top Edges.
Step 4 – Draw the Sides.
Step 5 – Draw the Edges Furthest from You.